Power Quality Analysis now more affordable Applications include power logging as well as load and energy surveys

Fluke 1730 Power Quality Analyser

Fluke 1730 Three-Phase Energy Logger is 25% cheaper than earlier models

  • Simplify detection of electrical energy waste
  • Measure voltage, current, power and power factor
  • Software allows comparison of multiple data points

February 2014 – PASS Ltd, the independent test equipment expert, claims that three-phase power quality analysis has never been more affordable with the launch of the Fluke 1730 energy logger, which is 25 percent cheaper than earlier models.

Three-phase AC electrical supply has a number of advantages over single-phase as the phase currents cancel each other out, allowing reduced neutral wire size in the case of star wiring or to eliminate it altogether in the case of delta wiring.

Three-phase supply can deliver more constant power transfer to reduce motor vibrations for example. However the quality of the AC supply from utilities is not always predictable and the Fluke 1730 helps identify sources of electrical energy waste.

“Fluke’s new Energy Analyze software allows engineers and plant managers to compare multiple data points over time to build a complete picture of energy usage,” says Barry Atkins, managing director of PASS Ltd.

“More than 20 separate logging sessions can be stored on the instrument. Optimising peak demand and power factor usually results in lower monthly electricity bills. The Fluke 1730 logger has measures and characterise these effects enabling users to analyse the results and save money.

“By means of a load study, it is possible to determine how much energy individual pieces of equipment are consuming when they are operating at minimum and maximum capacity and to check the capacity of circuits prior to adding further loads.

“Load studies can also help identify situations where the allowable load on the circuit may be exceeded or when an agreed peak demand applies from the utility.”

Measurements should be taken for energy surveys at multiple points within a plant or facility, start at the main service feeders to compare the power and energy measured with readings from the utility meter to ensure the correct charges, and then moving downstream to larger loads.

For situations where it is either difficult or impractical to make a voltage connection, a simplified load study may be performed by measuring current only. The user can enter the nominal expected voltage to create a simulated power study. For accurate power and energy studies it is required to monitor both voltage and current but this simplified method is useful in certain circumstances.

For further information visit PASS Ltd’s specialist Power Quality Analysers web page.

You may also like...